Advanced Operations - WEIHONG 200 Series Manual

7 Advanced Operations

Through this section, you can know the following customized operations:
• Load / unload material
This operation is used to achieve one of the following actions:
– Load material: the system automatically sends the machining workpiece
to the machining position.
– Unload material: the system automatically takes off the machined
workpiece from the machining position after machining ends.
– Load and unload material: the system automatically sends the
machining workpiece to the machining position, and then automatically
takes off the machined workpiece from the machining position after
machining ends.
• Change tool by cylinders
This operation is used to change tool for machine tools with multi-cylinders.
• Change tools for different types of tool magazines:
This operation is used to change tool for the following types of tool magazines:
– Linear tool magazines
– Circular tool magazines
– Double circular tool magazines
– Servo tool magazines
– Double servo tool magazines
Note: Changing tool by the last two types of tool magazines is not supported in NK260.
• Enable gang drills
This operation is used to change the gang drill or saw blades for machine tools
with gang drills or saw blades.
• Start machining with double stations
This operation is used to switch stations in turns for machining, so as to
improve machining efficiency.
At present, it is mainly used for labelling.
Please contact our technic sales engineers if you need to customize these operations.
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
52 / 52