Ip Settings - TRENDnet TEW-826DAP User Manual

TRENDnet User's Guide

Access Point: In this mode, the device creates a wireless network to your
existing network.

Client Bridge: Select this mode to allow the access point the ability to
wireless connect to your wireless network. This is similar to a wireless
laptop or mobile device connecting to a wireless network.

WDS Access Point: In the mode, the access point connects to other WDS
bridge enable devices for backbone communication and provides wireless
connection to clients (STAs) at the same time.

WDS Bridge: When this mode is selected the access point connects ONLY
to other WDS bridge enabled devices and local networks (the other
wireless interface and Ethernet interface) as a wireless backbone bridge.

WDS Station: The wireless interface connects to other WDS bridge enabled
devices for backbone communication and connects to other wireless
access points at the same time. Use this mode to pair with the next hop
access point as a WDS network outlet.

Note: Please note that only one bridge can be set up on 2.4GHz or 5.0GHz
band, but not both.

Repeater: In this mode, the wireless interface repeats wireless signal and
packets for backbone communication as well as a client access. This
feature is used to expand your existing wireless network to areas that your
current access point is unable to reach. Make sure all of the settings of the
wireless interface matches to your root or connecting wireless access
points, same SSID, channel and wireless encryption settings.
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
© Copyright 2018 TRENDnet. All Rights Reserved.

IP Settings

System > IP Settings
In most cases, you do not need to change the IP address settings. Typically, the IP
address settings only needs to be changed, if you plan to use another access point in
your network with the same IP address settings, if you are connecting your access point
to an existing network that is already using the IP address settings your access point is
using.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your device's IP address settings
as default. Default IP Address and Subnet mask: 192.168.10.100 / 255.255.255.0
1. Log into your management page (see
8).
2. Click on the System tab and click IP Settings.
3. Review the settings and click Save to save changes.

Connection Type: Select on the pull-down menu the LAN connection type.
o
DHCP: Select this option to have the access point obtain an IP
address from your DHCP server
o
STATIC: Select this option to manually assign and IP address to
your access point

DNS Server: Enter your network's DNS server IP address
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
TEW-826DAP
"Access the management page" on page
15