TRENDnet TEW-826DAP User Manual page 45

TRENDnet User's Guide

DTIM: DTIM is a countdown informing clients of the next window for
listening to
broadcast and multicast messages. When the access point has buffered
broadcast
or multicast messages for associated clients, it sends the next DTIM with a
DTIM
Interval value. Wireless clients detect the beacons and awaken to receive
the
broadcast and multicast messages. The default value is 1. Valid settings are
between 1 and 255.

Guard Interval: Select to enable short guard interval (400ns).

MPDU: MPDU aggregation also collects Ethernet frames to be transmitted
to a
single destination, but it wraps each frame in an 802.11n MAC header.
Normally this is less efficient than MSDU aggregation, but it may be more
efficient in environments to maintain performance in noisy networks and
to prevent hidden nodes from degrading the performance.

Client Limit: Select enable to turn on client limit of the select wireless band

Max Client: Enter the amount of clients to allow
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
© Copyright 2018 TRENDnet. All Rights Reserved.
TEW-826DAP
42