Internal Captive Portal - TRENDnet TEW-826DAP User Manual

TRENDnet User's Guide

Secondary RADIUS Server – If you have secondary or backup CoovaChilli
authentication server, enter the IP address.

RADIUS Auth Port – Enter the port number used by the CoovaChilli server
for authenticating RADIUS requests. The default port number used for
RADIUS authentication is 1812.

RADIUS Acct Port – Enter the port number used by the CoovaChilli server
for accounting on the server. The default port number for RAIDUS
accounting is 1813.

RADIUS Shared Secret – Enter the shared secret used to allow the
CoovaChilli server to allow the access point to authentication RADIUS
authentication requests.

RADIUS NAS ID: Enter the NAS ID required by the CoovaChilli server to
allow the access point to authentication RADIUS authentication requests.

UAM Portal URL – Enter the UAM portal web URL address of the login
authentication page provided by the CoovaChilli server.

UAM Secret – Enter the UAM secret required to allow access to this
portal page.
6. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.

Internal Captive Portal

Note: The internal captive portal function works on HTTP web port 80. Once enabled, in
order to log back in to the access point management page, when prompted for
credentials in the captive portal page, enter the access point administrator user name
and password (default: admin / admin). After you have logged into the captive portal
page with the access point administrative account, you will be redirected to the main
access point management page for device configuration.
1. Log into your management page (see
8).
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access the management page" on page
2. Click on the System tab and click Captive Portal.
3. Choose the Captive Portal mode Internal Captive Portal.
First, enable Captive Portal, enter user name and password accounts for users to
authenticate and set an authentication timeout value. Then click Save at the bottom of
the page to save the settings.
Select the Login Method for connecting to your captive portal WiFi network. At the
Login Method drop-down list, select one of the following.

User name and password – Requires users to enter a user name and
password for authentication to connect to your captive portal WiFi
network which must be defined in the Users List.
Note: Multiple users can use the same user account to log into your captive
portal WiFi network.
o
To create a new user account, next to Setting Username and
Password, enter the user name and password for the new user
account and click Add. Repeat to add more user accounts.
TEW-826DAP
19