YASKAWA SI-EP3 Installation Manual page 27

Procedure B
n
This section shows the procedure to install and wire the option on a GA700 or GA800 drive.
Prepare the Drive for the Option
Before you install the option on a YASKAWA AC Drive GA700 or GA800, make sure that
the option software version is PRG: 4400 or later.
1. Correctly wire the drive as specified by the manual packaged with the drive.
2. Make sure that the drive functions correctly.
Refer to Figure 11
components for reference in the installation procedure.
Figure 11
L
K
J
A – Insertion point for CN5 connector
B – SI-EP3 option
C – Included screws
D – Drive front cover
E – LED label
F – Keypad
G – Option modular connector CN1
port 1
H – Option modular connector CN2
port 2
YASKAWA ELECTRIC TOBP C730600 89D YASKAWA AC Drive Option SI-EP3 Installation Manual
for an exploded view of the drive with the option and related
I
H
G
Figure 11 Drive Components with Option
5 Installation Procedure
A
B
C
I – LED Status Ring board
J – Connector CN5-A
K – Connector CN5-B
(Not available for communication
option installation.)
L – Connector CN5-C
(Not available for communication
option installation.)
A1000
A1000
E
D
F
27