Mounting The Lens Unit - NEC NP-02HD Installation Manual

Setting Up Your Projector

2-7. Mounting the Lens Unit

The lens units that can be attached to this projector are shown in the following table.
NC-60LS12Z
NC-60LS14Z
NC-60LS16Z
NC-60LS19Z
NC-60LS24Z
NC-60LS39Z
• The other NEC optional lenses are not available on this model.
NOTE
• The projector and lenses are made of precision parts. Do not subject them to shock or excessive forces.
• Remove the lens unit when moving the projector. If not, the lens could be subject to shock while the projector is
being moved, damaging the lens and the lens shift mechanism.
• When removing or installing the lens unit, return the position of the lens to the center before turning off the power
to the projector. If the position of the lens is not returned to center, the front cover will interfere with the lens and the
cover cannot be removed or installed.
• When installing or removing the lens unit, first confirm that the main power switch to the projector is off, and then
disconnect the AC power supply. After the AC power supply has been disconnected, allow the projector to suffi-
ciently cool before starting this work.
• Never touch the lens surface while the projector is operating.
• Be very careful not to let dirt, grease, etc., on the lens surface and not to scratch the lens surface.
• Perform these operations on a flat surface over a piece of cloth, etc., to prevent the lens from getting scratched.
• When leaving the lens off the projector for long periods of time, mount the lens mount cap on the projector to
prevent dust or dirt from getting inside.
• If you remove the lens cover, a tamper event is detected by the tamper detection circuit. When you start the projec-
NOTE
tor after attaching the cover, the following error message is displayed on the LCD screen of the projector main unit.
- "IMB: Service Door Tamper" (When NP-90MS01 mounted)
• Encrypted contents cannot be displayed while an error message is being displayed. Refer to "3-2. Recovering from
Tamper Errors" (page 103) for details on how to clear the error message.
94
MODEL Magnifying
1.20 - 1.81
1.40 - 2.05
1.59 - 2.53
1.90 - 3.25
2.40 - 3.90
3.90 - 6.52