NEC NP-02HD Installation Manual page 114

Projector Adjustment and Connecting
1-2. Remove the FMT board.
(1) Remove the three clampers shown in the upper
figure and the five clampers shown in the lower
figure.
(2) Remove the four M3 screws from the FMT
board.
(3) If the FMT board is lifted, it will hit the fan flange,
so slide it first then remove it.
Place the removed board on top of the fan.
NOTE
- Do not disconnect the connector.
Do not place the board on the circuit
board.
114
(3)
(2)