(2)
Once the position is set, tighten with the four M6 cross-slot upset screws (temporarily fixed to the light module
base) and the two M5 cross-slot upset screws (included with the main unit).
(3)
Remove the dedicated positioning bars.
Use the M5 screws included
with the main unit for these two
screws.
5
Connect the cooling hoses.
Press the joints of the two cooling hoses on the main
unit and the light module in until they click into place.
The joint locks when it is pressed in.
Pull to check that the hoses do not disconnect.
- To disconnect, press in the white button and pull out.
Installation of the light module
Cooling hose
Cooling hose
31