NEC NP-02HD Installation Manual page 132

LCD Menu
[CG Adj.]
Use the function to adjust CG.
This menu can be used only during standby
On the confirmation screen shown by pressing the ENTER button, selecting "Yes" and pressing the ENTER button automatically
starts up the projector to project an image for the CG adjustment. During the use of this function, the pattern cannot be changed.
[Shadow Adj.]
Use the function to adjust shadow. This menu can be used only during standby.
On the confirmation screen shown by pressing the ENTER button, selecting "Yes" and pressing the ENTER button automatically
starts up the projector to project an entirely white image. During the use of this function, the output of the light source cannot be
adjusted (Light Setup).
[Lens Mount Adj.]
Use the function to adjust the lens mount (focus balance adjustment).
This menu can be used only during standby.
On the confirmation screen shown by pressing the ENTER button, selecting "Yes" and pressing the ENTER button automatically
starts up the projector to project a green cross-hatching image. During the use of this function, the output of the light source cannot
be adjusted (Light Setup).
[Demo]
Use the function to switch to the special mode to increase the contrast ratio.
If you wish to use the function, consult your dealer.
[USB Maint]
Use the function to install software or data for the projector by using the USB flash drive in which a release package for updating
the projector or a backup file for the projector is saved. For details, refer to the service manual.
132
← Pressing the ENTER button executes this function.
← Pressing the ENTER button executes this function.
← Pressing the ENTER button executes this function.