NEC NP-02HD Installation Manual page 99

1
Remove the side panel.
Side panel of the projector should be removed to mount the option board. For the procedure of removing the side panel,
refer to "1-5-2. Removing and Mounting the Side Panel" (page 53).
2
Remove the blocking panel from slot.
1. Loosen the knurled screws (2 places) of slot until their rotations become idle ( ). Screws
cannot be removed.
2. Remove the blocking panel ( ).
Slot
Carefully store the blocking panel and screws that you removed.
NOTE
3 Mount the option board to the projector.
1. Insert the board by following the guide on either side of the slot.
2. While pushing up and holding the board, tighten up the knurled screws (2 places) until
it fix.
4 Mount the side panel to the projector.
This completes the mounting of option board. Next, clear any tamper events. For details on how to clear tamper events, refer to
"3-2. Recovering from Tamper Errors" (page 103). A setting to use option board is needed, after recovering from tamper error. For
the procedure, refer to "2-8-1. Make the option board usable" (page 100).
guide (left/right)
Setting Up Your Projector
99