Lcd Menu; List Of Menu - NEC NP-02HD Installation Manual

4. LCD Menu

This chapter describes the menus displayed in the LCD screen on the projector's control panel and their functions. For basic opera-
tions of menus, refer to the projector's operation manual.

4-1. List of Menu

Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used.
Main menu
Title Select "Title Memory Name"
TEST Pattern
Configuration Light Setup
Lens Control
Reset
(Setup)
Installation
(Note)
(Memory)
(Title Setup) Preset Button
118
Submenu
Selects the title of the signal to be projected.
Selects the test pattern to be projected.
Adjust Adjusts light source brightness.
Lens Position Adjusts the position of the projected screen.
Focus Zoom Adjusts the size and focus of the projected screen.
(FactoryDefault) Returns the settings to their default values. Selects between preset
buttons and titles only, LAN settings only and all settings.
Filter Cleaning Initializes the air filter usage time (for confirming the filter cleaning
time).
(Fan Usage) Initializes the usage time of the fan.
(Light Usage) Initializes the usage time of the light source.
(Phosphor) Initializes the usage time of the Phosphor.
(Diffuser) Initializes the usage time of the Diffuser.
(Pump) Resets the pump usage time.
(Douser Count) Resets the number of times the douser has been used.
Douser Setup Sets the douser open/close state.
Panel Key Lock Locks the buttons on the projector's control panel so that they
cannot be operated.
Auto Key Lock Enables or disables Auto Key Lock.
3D Reference Sets the input terminal for 3D video system.
Off Timer Sets the time until the projector power is turned off automatically.
Message Sets the time to display the message indicating the air filter cleaning
cycle.
Silent Mode Sets whether the rear (SYSTEM/LIGHT) status indicator, buzzer,
indicators on the projector's control panel, illumination, and
LCD screen backlight are enabled or disabled.
(Option Slot) Configures the device installed in slot (only when the projector is in
standby mode).
(Orientation) Sets the projection method and cooling fan operating mode.
Lens Type (Note) Sets the type of lens (supports or does not support the lens
memory function) attached to the projector.
Lens Calibrate Performs calibration on lens that support the lens memory function
(Note) (only when the projector power is turned on).
Lens Center (Note) Moves the lens shift position to the center (only when the projector
power is turned on).
(Baudrate) Sets the PC control terminal (RS-232) data transmission speed
(bps).
(Date/Time) Sets the date and time on the projector.
(Fan Speed Mode) Sets the cooling fan operating mode.
(Service) Displays the Service man Menu.
The content of the selected light memory (light output power value)
Light
can be overwritten with the current settings.
Lens The content of the selected lens memory can be overwritten with
the current settings.
Preset Button 1–16 Sets the title to be assigned to the preset buttons (<1> to <10>
buttons).
Description
Reference
page
122
122
123
123
123
124
124
125
125
125
125
125
125
126
126
127
127
127
127
128
128
129
129
129
129
129
130
130
131
133
135