NEC NP-02HD Installation Manual page 29

3
Place the light module on the main unit.
CAUTION
・ The light module (NP-24LU01 and NP-
20LU01)* weighs approximately 65 kg. To
avoid lower back pain, it should only be in-
stalled by multiple people.
* The NP-18LU01 weighs approximately
56 kg.
・ When placing it on the main body, be care-
ful not to crush your fingers.
・ There are four mounting screw holes for eye
bolts in the light module.
Do not use them for anything other than
suspending the light module. Otherwise the
projector may be damaged.
(1) Remove the dustproofing section of the light
source socket.
(2) Line up the notches in the light module's base with
the three stoppers and place them over the inside
of the stoppers.
NOTE
Make sure that the light module's base is
flush against the main unit.
[Main unit]
Opening the fan bracket
Remove the three M4 screws, open the fan bracket, then turn
the stopper downward.
NOTE
Be sure to apply the stopper to prevent crushing
your fingers.
When closing the fan bracket, set the stopper back in its origi-
nal position and tighten it together with the frame.
Installation of the light module
If placing the light module on the main unit by hand, open the
fan bracket and hold the upper part of the frame.
[Light module]
Stopper
29