Furniture Door Panel; Gap - Miele F 31202 Ui Operating And Installation Instructions

Furniture door panel

Gap

Depending on the style of kitchen fur-
niture, the thickness and edge radius of
the furniture door and the gap that runs
around the door, vertically and horizont-
ally, are specified.
It is essential to pay attention to the fol-
lowing!
If the gap between the appliance fur-
niture door and the adjoining housing
unit door or wall on the hinged side
is too small, the appliance door
could collide with the adjoining hous-
ing unit door or wall when opened.
It may be necessary to adjust the
size of this gap to suit the thickness
and edge radius of the appliance fur-
niture door.
This must be taken into consideration
when planning your kitchen and when
replacing an old appliance with a new
one to ensure the installation conditions
required are met.
Appliance
furniture
door
thickness
A [mm]
R0
≥16 - 19
20 5
21 5.5
22 6.5
Adjoining kitchen furniture front
A = Furniture front thickness
B = Edge radius
X = Gap
Adjoining side wall
A = Furniture front thickness
B = Edge radius
X = Gap
Tip: Fit a spacer between the housing
unit carcase and the side wall. This way
you will get a sufficiently wide gap.
Installation
Gap X [mm]
for different
edge radiiB
R1.2 R2 R3
Min. 3
4 4 3.5
5 4.5 4
6 5.5 5
47