Westinghouse WFE904SC User Manual page 42

INSTALLATION OF THE APPLIANCE
Freestanding installation (continued)
Installation of screw-in feet
• Freestanding appliance are supplied with four
screw-in feet in the internal accessory pack.
The screw-in feet can be adjusted by turning the
lower half clockwise or anti-clockwise.
IMPORTANT
TIPS & INFORMATION
• WFE904SC is supplied with two silver feet and
two black feet, it is recommended to install the two
sliver feet at the front of the appliance for the best
aesthetics.
• To minimise the weight of the oven for easier
installation, remove the oven door and oven internal
accessory pack. Refer to page 35 for instructions on
how to remove the oven door.
• If the appliance is a gas hob model, remove the
burner cap and burner crown. Store all items safely,
away from the installation area.
Tilt and carefully lay the appliance on its back to gain
access to the installation point for the screw in feet.
CAUTION WARNING
• To avoid scratching the floor and the appliance
itself, fold the packaging carton board and place
it underneath the appliance as protection.
• Do not lay the appliance on its sides or its front.
42
INSTALLATION OF THE APPLIANCE
Install the four supplied feet via the four installation
points. Make sure that each foot is securely fastened.
CAUTION WARNING
• Do not over-torque the foot.
Adjust the height of the screw-in feet to make sure the
hob surface is 10mm above the bench when appliance
is upright.
Tilt the appliance upright by lifting the back of the hob
and pivoting it about the back two feet.
WARNING
WARNING
• Heavy item! This step must be performed by two
persons.
x 2