Installing Burners And Trivets - Westinghouse WFE904SC User Manual

INSTALLING BURNERS
AND TRIVETS
Installing burners
The burner crown must be fitted correctly into the
burner cup or damage will occur during operation.
• To do this, ensure that the 2 ribs on either side of the
spark plug hole are positioned into the 2 slots on the
burner cup.
• The burner cap and burner crown must be clean and
located correctly for the burner to light.
NOTE: When the burner is correctly fitted it will sit level
on the hob.
Installing trivets
• The rubber feet on the trivets locate into the
contours of the hob.
• Take care when placing the trivets as dropping
them may damage the hob or trivet.
• The wok trivet sits on top of the trivet above the
wok burner (WFEP915SC only).
Wok burner
12

INSTALLING BURNERS AND TRIVETS

Burner cap
Burner crown
Flame
safeguard
sensor
Burner cup
Ignition
spark plug
Injector
Wok trivet
(WFEP915SC only)
Trivets
Burner cap
Burner crown
Trivet installation sequence
Install the middle trivet first by aligning the trivet with
the wok burner and gently placing the trivet on hob.
The middle trivet is designed to guide the location
of the side trivets. Gently place the side trivets in the
orientation shown.
2
Corner support Self-locating tabs
Corner support
Flame safeguard models WFE904SC, WFE914SC
& WFEP915SC
Models with flame safeguard have the same ignition
procedure as electronic ignition, but require the knob to
continue to be depressed after flame is established for
approximately 5 seconds. If the flame goes out when
the knob is released, simply depress the knob again, this
time holding it down with slightly more force for the
same length of time.
WARNING
WARNING
• Keep hands clear of burners when lighting.
• If burner does not light within 5 seconds, turn
knob to 'Off' position, allow gas to disperse, then
try lighting again.
• Burners MUST be operated between 'HIGH' and
'LOW' settings only.
ENVIRONMENTAL TIPS ENVIRONMENT
To conserve gas, place the pan centrally over the burner
and adjust the flame so that it does not go past the edge
of the cookware.
NOTE: In the absence of electrical power, carry out
the ignition directly to the burner with a hand held
ignition source.
2
1
Self-locating tabs