Ethernet Connection (Direct) - ComAp InteliSys NTC Basebox Communications Manual

3.2.5 Ethernet connection (Direct)

Controllers
Controllers IG-NT-BB
Connection
applicable
Available
external bridge
ports
More info
Controllers
Connection
applicable
Available
external bridge
ports
Note: Ethernet connection is available for all mentioned controllers via external internet bridge or IB-NT (see
Ethernet connection via IB-NT on page 34).
Number of clients connected simultaneously
2 clients with InteliMonitor or Web Server (Comap/TCP protocol)
2 clients with web interface
Ethernet connection settings
Perform the connection settings the same way as for
Note: The IP addresses of the controllers must be accessible from the remote computer. If the remote
computer is connected into another LAN segment than the gen-sets are, there must be a gateway(s) that enable
direct traffic between the segments. If the remote computer is connected via Internet, then the internet gateway
of the LAN where gen-sets are connected must have public IP address, must allow incoming traffic and must
provide port forwarding from the external public IP to the different internal gen-set IPs according to the port
used.
IGS-NT Communication Guide
IG-NTC
NO YES
ETHERNET
IG/IS/IM-NTC-BB - Communications (page 12)
IG-NT IG-NTC
NO
external bridge
IS-NTC-BB
YES
ETHERNET
IS-NT-BB
NO NO
external bridge
Ethernet connection (Direct) (page
IM-NTC-BB IM-NT-BB
YES NO
ETHERNET external bridge
IM-NT
NO
external bridge
27).
35