Download Print this page

Beretta EXCLUSIVE C Series Installation And User Manual page 2

Gas adaptive condensing boiler
Hide thumbs Also See for EXCLUSIVE C Series:

Advertisement

"Thank you for purchasing this Beretta Exclusive condensing boiler"
EXCLUSIVE C complies with basic requirements of the following Directives:
EN
- Gas directive 2009/142/EC
- Efficiency directive: Article 7(2) and Annex III of directive 92/42/
EEC
- Electromagnetic compatibility directive 2014/30/EU
- Low-voltage directive 2014/35/EU
- Directive 2009/125/EC Eco design for energy-using appliances
- Directive 2010/30/EU Indication by labelling of the consumption of energy by energy-related products
- Delegated Regulation (EU) No. 811/2013
- Delegated Regulation (EU) No. 813/2013
-
Delegated Regulation (EU) No. 814/2013
Within this manual there are sections in
and the prohibition of actions other than by a qualified engineer The manufacturer is not Liable for any failure
to observe the requirements set out in this manual or relevant New Zealand code.
Some prohibited actions are also noted by the symbol
Note : User relevant sections are presented with
This instruction manual contains data and information for
both the user and the installer. The user of the use of the
appliance, must also refer to chapters:
Warnings and safety (Next page)
Maintenance
The user must not perform operations on the safety devices, replacing parts of the product, tamper with or
attempt to repair the appliance. These operations must be entrusted exclusively to qualified persons.
Important note regarding service requirements
Servicing of this appliance must be carried out at 12 month intervals
The servicing engineer
Minimum service must include the specific actions listed
Pay specific attention to the requirement to replace the burner chamber seal at each service,
Installer's-user's manual
Boiler operating elements
Electric diagrams
Hydraulic circuit
Circulator residual head
RANGE RATING
This boiler can be adapted to the heat requirements of the system, it is possible to set the range rated
parameter as shown in the specific paragraph. If applied the engineer must note the set value on the
adhesive label supplied for successive maintenance, engineers to refer to this adjusted value.
red text
these should be noted especially where they refer to safety
must pay particular attention to Pages 28 / 40 Service requirements
3-28
P
green text
40
41
42
43
0051
51C S4793

Advertisement

loading

This manual is also suitable for:

Exclusive 30cExclusive 25cExclusive 35c