Preparation Of Installation; Installation Regulations; Choice Of The Location - DeDietrich EVODENS PRO Series Installation And User Manual

4

Preparation of installation

4.1

Installation regulations

4.2

Choice of the location

Fig.4 Installation area
B
A
2
S1
1
S2
7725131 - v.01 - 06062019
Warning
The boiler must be installed by a qualified installer in accordance
with local and national regulations.
When choosing the best installation location, consider:
The regulations.
The required installation space.
The required space around the boiler for good access and to facilitate
maintenance.
The required space under the boiler for the installation and removal of
the siphon.
The permitted position of the flue gas outlet and/or air supply opening.
The evenness of the surface.
A ≥ 1000 mm
B 500 mm
C 500 mm
C
D ≥ 400 mm
E 750 mm
F 350 mm (siphon)
G ≥ 250 mm
D
If the boiler is installed in a closed cupboard, the minimum distance
between the boiler and the walls of the cupboard must be taken into
account.
1 ≥ 1000 mm (front)
E
2 ≥ 15 mm (left-hand side)
3 ≥ 15 mm (right-hand side)
Also allow for openings to prevent the following hazards:
Accumulation of gas
F
Heating of the casing
Minimum cross section of the openings: S1 + S2 = 150 cm
G
Danger
3
It is forbidden to store, even temporarily, combustible products
and substances in the boiler or near the boiler.
Warning
AD-3001371-01
Fix the appliance to a solid wall capable of bearing the weight of
the boiler when full of water and fully equipped.
Do not place the appliance above a heat source or a cooking
appliance.
Do not locate the boiler in direct or indirect sunlight.
Caution
The boiler must be installed in a frost-free area.
An earthed electrical connection must be available close to the
boiler.
A connection to the drain must be present for the condensate
drain close to the boiler.
4 Preparation of installation
2
AMC Pro 15