Reading The Installer's Name And Phone Number; Start-Up; Shutdown; Frost Protection - DeDietrich EVODENS PRO Series Installation And User Manual

System Settings menu
Set click sound
License Information
9.9

Reading the installer's name and phone number

9.10

Start-up

9.11

Shutdown

9.12

Frost protection

9.13

Cleaning the casing

7725131 - v.01 - 06062019
Settings
Enable or disable the click sound of the rotary knob
Read out detailed license information from the device platform application
The installer can set his name and phone number in the control panel. You
can read this information when you want to contact the installer.
1. Press the button.
2. Select System Settings
The installer's name and phone number is shown.
Start the boiler up as follows:
1. Open the boiler gas tap.
2. Power up the boiler.
3. The boiler runs through an automatic venting program lasting approx.
3 minutes.
4. Check the water pressure of the central heating system shown on the
control panel display. If necessary, top up the central heating system.
The current operating condition of the boiler is shown on the display.
If the central heating is not due to be used for a long period of time, it is
recommended that the boiler be disconnected from the power supply.
1. Shut off the gas supply.
2. Keep the area frost-free.
Caution
Drain the boiler and central heating system if you are not going
to use your home or the building for a long time and there is a
chance of frost.
The frost protection does not work if the boiler is out of
operation.
The built-in boiler protection is only activated for the boiler and
not for the system and radiators.
Open the valves of all the radiators connected to the system.
Set the temperature control low, for example to 10°C.
If the temperature of the central heating water in the boiler drops too low,
the built-in boiler protection system is activated. This system works as
follows:
If the water temperature is lower than 7°C, the pump switches on.
If the water temperature is lower than 4°C, the boiler switches on.
If the water temperature is higher than 10℃, the burner shuts down and
the pump continues to run for a short time.
To prevent the system and radiators freezing in frost-sensitive areas (e.g.
a garage), a frost thermostat or, if feasible, an outdoor sensor can be
connected to the boiler.
1. Clean the outside of the appliance using a damp cloth and a mild
detergent.
9 User instructions
> .Installer Details
AMC Pro 75