Requirements For The Flue Gas Outlet System; Classification - DeDietrich EVODENS PRO Series Installation And User Manual

4.7

Requirements for the flue gas outlet system

Tab.4 Type of flue gas connection: B
Principle
AD-3000924-01
(1) The material must also satisfy the material property requirements from the relevant chapter.
Tab.5 Type of flue gas connection: B
Principle
AD-3000925-01
(1) The material must also satisfy the material property requirements from the relevant chapter.
Tab.6 Type of flue gas connection: C
Principle
AD-3000926-01
(1) The material must also satisfy the material property requirements from the relevant chapter.
7725131 - v.01 - 06062019
4.7.1
- B
23 23P
Description
Room-ventilated version
Without down-draught diverter.
Flue gas discharge via the roof.
Air from the installation area.
The IP rating of the boiler is lowered to IP20.
33
Description
Room-ventilated version
Without down-draught diverter.
Joint flue gas discharge via the roof, with guaranteed natural
draft (at all times underpressure in the joint discharge duct).
Flue gas discharge rinsed with air, air from the installation
area (special construction).
The IP rating of the boiler is lowered to IP20.
13(X)
Description
Room-sealed version
Discharge in the outside wall.
Air supply opening is in the same pressure zone as the dis­
charge (e.g. a combined outside wall terminal).
Parallel wall terminal not permitted.

Classification

Important
The installer is responsible ensuring that the right type of flue
gas outlet system is used and that the diameter and length are
correct.
Always use connection materials, roof terminal and/or outside
wall terminal supplied by the same manufacturer. Consult the
manufacturer for compatibility details.
4 Preparation of installation
Permitted manufacturers
(1)
Connection material and roof
terminal:
Cox Geelen
Poujoulat
Ubbink
Permitted manufacturers
(1)
Connection material:
Cox Geelen
Poujoulat
Ubbink
Permitted manufacturers
(1)
Outside wall terminal and con­
nection material:
Cox Geelen
AMC Pro 17