Hydraulic Circuit; Electrical Connections; Control Panel Description; Control Panel Components - DeDietrich EVODENS PRO Series Installation And User Manual

6.2

Control panel description

Fig.53

Control panel components

3
4
6
5
7725131 - v.01 - 06062019
4. Check the gas inlet pressure at the measuring point C on the gas
valve unit.
Warning
The gas pressure that was measured at the measuring point C
must fall within the stated gas inlet pressure limits. See
Technical data, page 77
For authorised gas pressures, see: Unit categories, page 76
5. Vent the gas supply pipe by unscrewing the measuring point on the
gas valve unit.
6. Tighten the measuring point again when the pipe has been fully
vented.
7. Check all connections for gas tightness. The maximum allowable test
pressure is 60 mbar.
6.1.4

Hydraulic circuit

1. Check the siphon; it should be fully filled with clean water.
2. Check the water-side connections for tightness.
6.1.5

Electrical connections

1. Check the electrical connections.
6.2.1 Control panel components
1 Rotary knob to select a tile, menu or setting
2 Confirm button
3 Back button
Short button press: Return to the previous level or previous
menu
1
Long button press: Return to home screen
4 Menu button
5 Display
2
6 Status LED
For more information, see
Additional documentation, page 11
AD-3000932-01
6.2.2

Description of the home screen

This screen is shown automatically after start-up of the appliance. The
control panel goes automatically in standby mode (black screen) if the
screen is not touched for 5 minutes. Press one of the buttons on the
control panel to activate the screen again.
You can navigate from any menu to the home screen by pressing the back
button for several seconds.
The tiles on the home screen provide quick access to the corresponding
menus. Use the rotary knob to navigate to the menu of your choice and
press the button
6 Preparation of commissioning
to confirm the selection
:
to go to the main menu
to confirm the selection.
AMC Pro 49