Connecting The Standard Pump - DeDietrich EVODENS PRO Series Installation And User Manual

5 Installation
Fig.49 Connecting the power supply cable
1
4
X81
X81
46 AMC Pro
Caution
If the calorifier tank does not have a TAS anode, connect the
simulation anode (= accessory)
5.8.6
The pump must be connected to the standard control PCB. To do this,
proceed as follows:
1. Connect the X81 power cable supplied with the boiler to the pump.
2. Remove the grommet from the opening in the middle of the base of
the boiler.
3. Pass the pump X81 cable through the base of the boiler and seal the
opening by tightening the bayonet fitting to the cable.
4. Connect the X81 pump cable to the X81 cable that runs along the
cable duct to the left of the instrument box
2
3
X81
AD-4000093-01

Connecting the standard pump

7725131 - v.01 - 06062019