Logging Start and Stop
After setting the setup parameters (sampling interval, channels to be stored,...), press the
"Start Recording" key to start with immediate logging. Recording will immediately start,
independently on the type of Start Mode selected in the Setup.
Press "Disconnect" to disconnect the instrument, then disconnect the serial cable
To stop logging, connect the serial cable, start DeltaLog2 program, connect the instrument
and press the Stop Recording key. N.B.: If the keyboard has not been locked during setup,
logging can be stopped by pressing the LOG key on the instrument.
Data Dump
To dump data contained in the minidatalogger memory, connect the serial cable to the PC,
start DeltaLog2 program, connect the instrument (Connect key).
Press the "Dump data on PC" key. Once data have been dumped, they will be shown in
table format.
Press the Disconnect key to disconnect the instrument. Disconnect the serial cable.
43