Delta HD207 Series Instruction Manual page 15

Manual Logging:
done on the instrument keyboard; the same settings can be made from a PC using DeltaLog2
program.
1. Activate the "man" function in P02 program.
2. Set the sampling interval with P01program.
3. Set alarms, if desired, with steps from P06 to P09.
4. Start logging by pressing the LOG key: the
the LOG indication), will start flashing.
5. Press LOG again to stop logging.
Notes:
A) If the instrument is not logging and you press LOG, logging will start. If the instrument
built-in clock has been previously set on auto logging, the instrument will ignore the com-
mand and will go on logging. Pressing LOG or according to the automatic stop command
(the first one between the two) will interrupt logging.
B) If the instrument is already logging (either in manual or in auto), and you press LOG, log-
ging will stop. The eventual automatic stop command will be ignored.
Automatic Logging:
date, previously set. Here are the steps to be made from the instrument keyboard; the same set-
tings can be made from a PC, using DeltaLog2 program.
1. Make sure that the instrument date and time are properly set (program P03)
2. Activate the "man" function in P02 program.
3. Set the sampling time with P01 program.
4. Enter start time and date using P04 program.
5. Enter stop time and date using P05 program.
6. Set alarms, if desired, using the steps from P06 to P09.
7. Activate the "dat" function in P02 program.
press the LOG key to start and stop logging. Here are the operations to be
storage start and stop are performed according to established time and
symbol on display, (in correspondence with
15