View (For Hd206; Programming From Keyboard (For Hd206 - Delta HD207 Series Instruction Manual

View (for HD206... and HD207... models)
To switch the instrument on, open the keyboard cover and press the ON/OFF key. On the models
that measure two quantities (temperature and humidity or internal and external temperature), select
the variable to be viewed by using the F1/F2 key. If the key is pressed repeatedly, either the first
variable, the second one or, finally, the two variables alternately will be displayed. A triangle on the
display indicates the variable currently viewed: temperature or humidity in correspondence with
°C/°F and %RH; internal or external temperature in correspondence with Ti and Te.
If you select the single-channel view and an alarm becomes true, the instrument will automatically
turn to the alternating view to be able to display the alarm diagnostic. When the external probe with
cable (temperature or temperature/humidity probe) isn't connected, the message "Und" appears on the
display referred to the temperature channel and the message "ERR" referred to the R.H. channel: in
this case use the F1/F2 key to let the unused measuring channel disappear.
Programming from Keyboard (for HD206... and HD207... models)
The logging operation requires the preventive setting
of some parameters. The PROG key allows to access
the programming functions: if pressed repeatedly, the
different program steps will scroll from P00 to P10 and
again to P00 in a circular routine.
Once you have reached the desired step, press ENTER
to change its value.
ENTER from P00 step. The instrument programming
can also be made from a PC using DeltaLog2 program.
6
To go back to the view mode, press
P00 P01 p02 ... p10 p00
ENTER