File/Save as... It saves data downloaded from the instrument
Instrument/New Session It starts a new session and deletes data downloaded to the PC:
before closing, you will be asked if you want to save data. It does not clear the mini-
datalogger memory: to do it, use the "Clear Memory Now" command in the instrument
setup (see Instrument Settings at page 38).
Instrument/Connect It starts the instrument connection to the PC. Serial port settings
are automatically made by the program and no operator's action is required.
Instrument/Disconnect It disconnects the instrument at the end of the working session.
This command leaves the serial port available for other applications.
Instrument/Read Instrument It reads the measurements detected by the instrument and
displays them on the PC screen – see the related paragraph at page 41.
Instrument/Dump data It starts data dump from minidatalogger to PC
Instrument/Start Recording It starts data recording
Instrument/Stop Recording It stops data recording
33