Indoor Display - Pentair IntelliPool User Manual

Indoor display

The remote indoor display provides information on all the parameters (updates every 15 minutes) of the water quality and comfort.
Intended for internal use, pre-programmed alerts make it possible to check the chemical balance of the water at a glance without needing to
perform cumbersome analyses at the edge of the tank.
Moving the signal may cause a loss of signal. If it remains out of range for more than 1 hour, all the information is deleted.
The remote display can be placed on its tripod or fastened to a wall (after testing the signal range)
1: Air temperature (°C or °F)
3: Pool cover rolled
5: Operation without heat
7: Sand filter alert
9: IntelliFlo® alert
11: Alarm mode
13: Radio mode
15: Acoustic alarm OFF
17: IntelliChlor® alert
19: Filter cleaning requested
21: Batteries level
23: Value of RedOx in mV
25: Auto-adaptable units (g / l) or (µS)
27: Tick for a correct value
29: Spot light ON
31: Risk of snow
1
2
3
4
5
6
7
9
10
11
12
13
14 15
2: Water temperature (°C or °F)
4: Heating alert
6: Heating running
8: N/A
10: IntelliFlo® running
12: Calibration mode
14: Acoustic alarm ON
16: IntelliFlo® alert
18: N/A
20: Indoor display batteries level
22: Radio force signal
24: Salt concentration (g / l) or conductivity (µS) value
26: pH value
28: Water temperature alert (<+3 °C)
30: Pool cover closed (closed pool)
32: Temperature unit (°C or °F).
16
17 19 20
calib on alarm
32
31
Water/air alternating display
30
29
1 = Escape
Goes back to the previous step without taking modifications into account
2 = Downward movement/decrementation
28
- Navigation downwards in drop-down menus or decrementation of values in numerical spaces
27
3 = Upward movement/incrementation
- Navigation upwards in drop-down menus or incrementation of values in numerical spaces
4 = Validation
26
- Makes it possible to access the displayed parameter or approves the modifications and returns
to the previous menu
25
24
23
21 22
1 2 3 4
29