Preparation Of The Pc; Re-Programming Mode; Control Center: How To Update The Internal Firmware P - Pentair IntelliPool User Manual

Control Center: How to update the internal firmware
The Control Center can be updated or reflashed. This procedure is reserved for qualified professionals with good IT knowledge. The update file is
available at Intellipool.eu/téléchargement.

1 - Preparation of the PC

- Make sure to have a surface to place the laptop on.
- Installing this program will ensure that the PC can send the required file via USB
1.1 Unzip the file MAJ_Intellipool_Vx_xx.zip
1.2 Double click on USBXpressInstaller.exe
1.3 In the Silicon Laboratories USBXpress Device Driver Installer window,
click Install
1.4 In the Success window which has opened, click OK

2 - Re-programming mode

- To read the version number of the Control Center, simply cut the electrical power supply and quickly look at the bottom right of the screen during
powering on. The display is in the form x.xx or xxx. The minimum version compatible for this operation is 3.51.
2.1 - Press 2.2 - Cut for 3 sec. then re-supply
Press the the power while keeping the button pressed
Up/+ button
3 s
2.8 Double click USBBootloader.exe from the archive MAJ_xxxxxxx_Vx_xx.zip
2.9 Click Open
2.12 Click Download
Version No. which is going to be programmed
3 - Loading of the latest menu texts
- The menu texts evolve as the functions change. Updating the internal text file makes full use of the functions possible.
3.0 On the PC, open the Control Center file (visible as USB media)
3.1 Open the file Texts from the archive MAJ_xxxxxxx_Vx_xx.zip
3.2 Copy the file content Texts from the archive MAJ_xxxxxxx_Vx_xx.zip in the file of the Control Center.
As the new .TXT files have the same name, they will overwrite the old ones (click OK for the overwrite request).
The update is finished. Disconnect the mini USB cable from the Control Center.
42
- In FILTRATION AUTO mode, it is normal that the filtration does not start again immediately. It will restart on the next full hour.
2.3
- Press
the Up/+ button
for 3 more sec.
C O N T R O L
12/07/2018 15:23:48
Water temp.:+24.0°C
pH: 7.3 RedOx:629mV
Cond:5571uS 3.51g/l
ESC VALID
2.10 Click Browse...
2.13 In the USB Bootloader window,
click OK
1.3
2.5 Remove the orange cover of the Control Center
2.4
2.6 Connect the USB/mini USB cable
- Then release.
between the PC and Control Center
2.7 The PC displays USB recognised
3 s
Current version No.
2.14 Cut the supply for a min. of 3 sec
2.15 Press Esc and Valid
and simultaneously
reconnect the power supply.
2.16 As soon as it lights, for 2 sec,
check the version number
1.4
USB
recognised
230 V
~
example
2.11 Open ControlCenter_3_5_5_MAJ.hex
I nit ial is at io n. . .
I n it.:re se t
BUS
3 s
C O N T R O L
ESC VALID
Pe nt air
I nte l l iPo ol
v 3 5 5