Risk Of Ice Formation; Mode In Progress; Activation/Deactivation Of Sound; Battery Level - Pentair IntelliPool User Manual

Mode in progress

Activation/deactivation of sound

Sound disabled
Sound activated

Battery level

1 2
1 : Batteries are full
3
4
1
2
3
4
5
1 : Very high

Risk of ice formation

The "Water" message displays if the water temperature is below +3 °C (37.4 °F). There is a risk of ice formation; intervention
is necessary to avoid damage to the pool and to the hydraulic installation. If the filtration is connected, the Control Unit will
automatically launch filtration. In the case of a heated technical room, the alert threshold can be voluntarily shifted by +3 °C
in the Control Center/Settings/Install/Filtration menu.
Alarm and calibration correspond to the position of the switch at the back of the indoor display. RADIO indicates that the set
is in radio learning mode on the IntelliPool network.
On the indoor display, a sound alert for the different alarms as well as a discreet beep button are available.
This pictogram illustrates the activation and deactivation of the sound which can be accessed by a switch located on the back.
- The battery level displayed under the pictogram represents each element concerned.
- The battery service life is greater than 1 year, but may vary depending on weather conditions and use.
> As soon as the level is at "low batteries', the batteries should be changed.
2 : Batteries are OK 3 : Batteries are low
Radio signal strength
The radio range of the IntelliPool network depends on the geographical installation of the radio relay and the indoor display
(a long distance, a pool which is raised in relation to the house and the presence of a perimeter wall are detrimental), the
house material (reinforced concrete and a metallic building are detrimental) and the radio relay support (a metal stake or
galvanised rainwater downpipe are detrimental ). If the network signal remains too low or non-existent after tests of different
positioning configurations of the radio relay, place a second radio relay between the technical room and the indoor display to
optimise the signal strength (perform tests before fixing the elements). Adding an element to the radio network means that it
will be subject to the learning process (see p 31).
2: High 3 : Average
Pool cover position
For pools equipped with a pool cover and after connection to the Control Center, the position (cover rolled/closed is
displayed).
4 : Batteries are very low
4 : Low 5 : Very low
31