Setting Up And Starting Up; Setting Up; Display / Operating Elements; Starting Up - Atmos S 201 Thorax Operating Instructions Manual

3.0

Setting up and starting up

  
Fig 1




Fig 2
3.1

Setting up

●
Set up the device on a level, firm surface.
●
Connect the mains cable when charging the battery.
Mains voltage and fuse:
Mains voltage: 100-240 V; 50/60 Hz
Fuse: 1 x T 1A, L
●
USA/ Canada:
Use only „Hospital Grade" mains plugs and cords with
remark: Grounding reliability can only be achieved when
the equipment is connected ...). Cord type shall be SJ-
type and not smaller than 18 AWG and comply with CSA
C22.2No.21.
●
Australia:
Use only cords with plug Type AS 3112.
●
Singapore:
Plugs shall be rough-use-type, marked with „SS 145/A".
●
Denmark:
Plugs and sockets shall appply SB 107-2-D1, 3rd Edition
Plugs: DK 2-Ia, DK 2-Ia with flat phone pin or DK 2-5a,
Socket outlets: DK 1-3 a.







3.1.1 Display / operating elements


Symbol „start pump"

On/off switch

Symbol „stop pump"

Display

▼ adjusting key

▲-adjusting key

Enter / Menu / Reset

Therapy progress key
3.2

Starting up


Operating panel


Handle

Measuring channel

Suction channel

Display

Secretion container

Device status (LED)
●
Lift the unit out of the cardboard. Check whether the voltage
values on the data plate correspond with the inbuilding
voltage.
● Set up the device on a level, firm surface.

●
Prior to first operation, pay attention to the safety informa-
tion in chapter 2.0.
●
Prior to first start up the battery must be fully charged.
Charging time approx. 2.5 h.
●
The unit must be allowed to stand for up to six hours at room
temperature prior to starting up for the first time following
transport at temperatures below freezing. The unit may
not be operated if it has not acclimatised as this might
damage its piston.
●
The device can only be operated with the special
ATMOS container, therefore please take care to have at
least one spare container available.
9