Setting Up And Starting Up; Device Overview - Atmos C 451 Operating Instructions Manual

3 Setting up and starting up

 Always place the device on a firm and level surface.

3.1 Device overview

Front view
Vacuum connection: Direct Docking System
Connector panel on the bottom of the device
16 Setting up and starting up






DDS secretion canister lid

DDS secretion canister

Vacuum gauge

On/off switch

Vacuum regulator
 The vacuum connection between the pump and
secretion canister is established immediately
when the DDS secretion canister is attached.
Connecting the power cable:
 Only use power cables with angled IEC connec-
tors!
• Check that the mains voltage and mains frequen-
cy specified on the device correspond to the
values of the mains power supply.
Connecting the foot switch (option):
• Slide the knurled nut onto the hose of the foot
switch.
• Insert the hose of the foot switch onto the con-
necting nipple.
• Tighten the knurled nut
Vacuum connection on the bottom for the system
trolley
• To connect, press the coupler firmly into the
jack until it locks into place (serves to establish
a vacuum connection of the secretion canisters
attached to the system trolley).
• To remove, press the metal release button on the
side and pull the hose out of the jack.