Video Output Formats - TANDBERG C90 System Integrator Manual

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started

Video output formats

This section describes the video output formats for the TANDBERG
PrecisionHD 1080p camera.
DIP switch settings for video output formats
The video output format for the camera is set by DIP switches. The
DIP switches are found on the bottom side of the camera.
The default setting is Auto. When using HDMI, the video output format
is automatically detected. See the table to the right.
Maximum resolution for HDMI is 1080p60.
Maximum resolution for HD-SDI is 1080p30.
Line voltage frequency
The camera will automatically detect the line voltage frequency when it
is 50 or 60 Hz. You may set the video output format to a specific value
(use the DIP switches) to override the auto frequency detection, if a
different line voltage frequency is an issue.
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API
1
0
The DIP switch
Bottom side of the TANDBERG
PrecisionHD 1080p camera
xCommand xStatus Cameras
xCommand xStatus Cameras Cameras
DIP Switch table for video formats
1 2 3 4 5
0 0 0 0 0
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
0 0 1 0 1
0 0 1 1 0
0 0 1 1 1
0 1 0 0 0
0 1 0 0 1
The table shows the different settings available for the HDMI and
the HD-SDI outputs.
Auto: Camera negotiates format over HDMI. HD-SDI tracks HDMI
and defaults to 1080p30 in absence of HDMI sync.
Software: For more on the Software control setting, read about
video mode selections in the TANDBERG PrecisionHD 1080p User
Guide.
System Integrator Guide
Appendices Contact us
Appendices Contact us
HDMI HD-SDI
Auto
1920x1080p25 1920x1080p25
1920x1080p30 1920x1080p30
1920x1080p50 1280x720p50
1920x1080p60 1280x720p60
1280x720p25 1280x720p25
1280x720p30 1280x720p30
1280x720p50 1280x720p50
1280x720p60 1280x720p60
Software control
129