TANDBERG C90 System Integrator Manual page 36

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started
Connecting to the codec
Accessing XACLI
XACLI can be accessed through Telnet and SSH via the LAN interface
or through the COM port by connecting a serial cable to the serial
interface connector, referred to as the COM port.
The COM port (RS-232) is a 9-pin, female, D-sub connector located
on the back of the TANDBERG Codec C90. See the illustration to the
right.
The port is configured as a DCE (Data Communications Equipment).
The COM port (RS-232) is default set to 38400 baud, 8 data bits,
none parity and 1 stop bit from factory. The port may also be referred
to as the Data port.
Telnet/SSH login
Telnet is by default disabled. This can be changed with a configuration
command: xConfiguration NetworkServices Telnet Mode: On/Off
•
xConfiguration NetworkServices Telnet Mode: On
Telnet/SSH login
• User name is: admin
• Default password is: TANDBERG
Serial port login
The serial port is password protected by default. The password
protection may be configured.
• User name is: admin
• Default password is: TANDBERG
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API About the API
Serial port configurations
On the serial port the baud rate and password protection may be
configured.
The configuration command for the baud rate is:
xConfiguration SerialPort BaudRate: <9600/19200/38400/115200>
•
xConfiguration SerialPort BaudRate: 38400
The configuration command for login required is:
xConfiguration SerialPort LoginRequired: <On/Off>
•
xConfiguration SerialPort LoginRequired: On
Reboot. The system requires a reboot for the changes to baud rate
and password protection to take effect.
NOTE: When system boots up the baud rate of the boot messages is
38400 regardless of the baud rate set in the codec application.
Rev. Date
Rev. Date
116805 rev.
116805 rev.
Saturn C70 Unit
Saturn C70 Unit
3D CAD model le 116805
3D CAD model le 116805
xCommand xStatus
xCommand xStatus
The COM Port at TANDBERG Codec C90
Prep. Checked Change
Prep. Checked Change
Telecom AS
Sheet 1 of 1
Sheet 1 of 1
Telecom AS
European
European
projection
projection
Unit:
Unit:
Sheet size:
Sheet size:
Scale:
Scale:
rev. 00Z+ is master Part weight:
rev. 00Z+ is master Part weight:
System Integrator Guide
Cameras Appendices Contact us
Cameras Appendices Contact us
Line in Line in
Processes Tolerances
Processes Tolerances
-
-
-
-
-
-
mm Dimensions without paint or nish
Dimensions without paint or nish
mm
A3
All materials, nishes, and proccesses
A3
All materials, nishes, and proccesses
must comply with the RoHS directives
1:5 must comply with the RoHS directives
1:5
3172g Flame class requirement: -
3172g Flame class requirement: -
Speci cation:
Speci cation:
Type:
Type:
Manufacturer:
Manufacturer:
Type number:
Type number:
Thickness:
Thickness:
Color:
Color:
Surface:
Surface:
Glossiness:
Glossiness:
Flame class:
Flame class:
UL reference:
UL reference:
36