TANDBERG C90 System Integrator Manual page 49

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started
About xPreferences
The xPreferences command is used to set various preferences for the
RS-232/Telnet/SSH sessions.
Each session can define preferences individually.
IMPORTANT! This command has various settings to define the
formatting of the XACLI output. It is therefore important to define
settings to match the parser used on the control system. XACLI is
designed to make parsing of data from the TANDBERG Codec C90
very simple.
xPreferences output mode:
• Terminal: Line based XACLI output for use with line based control
systems
• XML: Pure XML output for use with control systems that
understand XML. NOTE! This mode is to be considered
experimental in version 1 of the software. Its format WILL
change in next version.
To get an overview of the supported xPreferences commands and
their value space, type ? or help after the xPreferences:
•
xPreferences ?
•
xPreferences help
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API About the API
xPreferences ?
xpreferences usage:
xpreferences outputmode <terminal/xml>
OK
xCommand xStatus Cameras
xCommand xStatus Cameras
System Integrator Guide
Appendices Contact us
Appendices Contact us
49