TANDBERG C90 System Integrator Manual page 79

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started
The Camera commands,
cont...
xCommand Camera ReconfigureCameraChain
Reinitialize camera chain. Get info about what camera is sitting in what position in the camera chain.
Example:
xCommand Camera ReconfigureCameraChain
*r ReconfigureCameraChainResult (status=OK):
*r/end
xCommand Camera TriggerAutofocus
Trigger the automatic focus functionality in the selected camera.
Parameters: Required parameters are marked with (r):
CameraId(r): <1..7>
Example:
xCommand Camera TriggerAutofocus CameraId:1
OK
*r TriggerAutofocusResult (status=OK):
*r/end
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API
xCommand xStatus
xCommand xCommand xStatus
The Dial command
xCommand Dial
Dial out from the system.
Parameters: Required parameters are marked with (r):
Number(r): <S: 0, 255>
Protocol: <H323/Sip>
CallRate: <64..6000>
CallType: <Audio/Video>
Example:
xCommand Dial Number:543210 Protocol:h323
OK
*r DialResult (status=OK):
CallId: 2
ConferenceId: 1
*r/end
System Integrator Guide
Cameras Appendices Contact us
Cameras Appendices Contact us
79