TANDBERG C90 System Integrator Manual page 80

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started
The DTMF command
xCommand DTMFSend
Send DTMF tones to the far end.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
DTMFString(r): <S: 0, 32>
Example:
xCommand DTMFSend CallId:2 DTMFString:1234
*r DTMFSendResult (status=OK):
*r/end
The Far End Control command
xCommand FarEndControl Camera Move
Move far end camera. The camera will move in the specified direction until the stop command is issued.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
Value(r): <Left/Right/Up/Down/ZoomIn/ZoomOut>
Example:
xCommand FarEndControl Camera Move CallId:3 Value:left
*r FECCMoveResult (status=OK):
*r/end
xCommand FarEndControl Camera Stop
Stop far end camera control move.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
Example:
xCommand FarEndControl Camera Stop CallId:3
*r FECCMoveResult (status=OK):
*r/end
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API
xCommand xStatus
xCommand xCommand xStatus
The Far End Control commands,
cont...
xCommand FarEndControl Preset Activate
Activate move of far end camera to preset position.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
PresetId(r): <1..15>
Example:
xCommand FarEndControl Preset Activate CallId:3 PresetId:1
*r FECCPresetActivateResult (status=OK):
*r/end
xCommand FarEndControl Preset Store
Store position of far end camera to a preset.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
PresetId(r): <0..15>
Example:
xCommand FarEndControl Preset Store CallId:3 PresetId:1
*r FECCPresetStoreResult (status=OK):
*r/end
xCommand FarEndControl Source Select
Select which video source to use as the main source on the far end system.
Parameters: Required parameters are marked with (r):
CallId(r): <0..65534>
SourceId(r): <0..15>
Example:
xCommand FarEndControl Source Select CallId:3 SourceId:1
*r FECCSelectSourceResult (status=OK):
*r/end
System Integrator Guide
Cameras Appendices Contact us
Cameras Appendices Contact us
80