TANDBERG C90 System Integrator Manual page 84

Codec C90
Contents Introduction Getting Started
Contents Introduction Getting started
The Preset commands
xCommand Preset Activate
Activate local preset. Will move camera to predefined position.
Parameters: Required parameters are marked with (r):
PresetId(r): <1..15>
Example:
xCommand Preset Activate PresetId:3
OK
*r PresetActivateResult (status=OK):
*r/end
xCommand Preset Clear
Delete a preset storing a camera position.
Parameters: Required parameters are marked with (r):
PresetId(r): <1..15>
Example:
xCommand Preset Clear PresetId:3
OK
*r PresetClearResult (status=OK):
*r/end
xCommand Preset Store
Store current camera position. System may hold 15 predefined camera positions (presets).
Parameters: Required parameters are marked with (r):
PresetId(r): <1..15>
Type(r): <All/Camera>
Description(r): <S: 0, 255>
Example:
xCommand Preset Store PresetId:3 Type:Camera Description:"Left view"
OK
*r PresetStoreResult (status=OK):
*r/end
D14128.03—JULY 2009
Interfaces About the API xConfiguration xConfiguration
Interfaces About the API
xCommand xStatus
xCommand xCommand xStatus
The SString Send command
xCommand SStringSend
Used to send data to far end, e.g. for control systems. Uses the H.224 data channel (UDP).
Parameters: Required parameters are marked with (r):
Message(r): <S: 1, 256>
CallId: <0..65534>
Example:
xCommand SStringSend CallId:4 Message:"This is a test"
*r SStringSendResult (status=OK):
*r/end
System Integrator Guide
Cameras Appendices Contact us
Cameras Appendices Contact us
84