B) Changing The Setpoint - Presys PCON-Y17 Series Technical Manual

PRESYS
 Instruments

b) Changing the setpoint

Press the SP button to change the setpoint to the desired value. When the
pressure is stabilized, its reading value turns to green.
Fig. 16 - Control Mode – Changing Set point Value
The state of the output isolation valve is user configurable. To change the state of
the valve, press the SETTINGS button shown below and change the Output Parameters
( OPEN / CLOSED) in the ADVANCED tab.
Page 18
Fig. 17 - Output Isolation Valve
PCON-Y17