Mytee -Lite 8070 Instructions Manual
Hide thumbs
Also See for Mytee-Lite 8070:
- User manual (20 pages) ,
- Instructions manual (12 pages) ,
- User manual (18 pages)
Advertisement
Quick Links
Instructions for
Mytee- Lite
8070
Please read before use.
Please read before use.
Register your product
at http://www.mytee.com/
support/register
Set up p. 3
General information p. 6
Parts & pricing p. 9
Wiring diagram p. 11
Notes p.12
™
13655 Stowe Dr., Poway, Ca. 92064
1
Model #
Serial #
Form # ADM-8070
8-13
Advertisement
Related Manuals for Mytee Mytee-Lite 8070
Summary of Contents for Mytee Mytee-Lite 8070
- Page 1 Instructions for Mytee- Lite 8070 ™ Please read before use. Please read before use. Register your product at http://www.mytee.com/ support/register Model # Set up p. 3 General information p. 6 Serial # Parts & pricing p. 9 Form # ADM-8070 Wiring diagram p.
- Page 3 ENGLISH 8070 MYTEE-LITE™ FRONT BACK 1. Vacuum Lid 7. Handle with Storage Basket and Cord Wrap 2. Vacuum hose connector 8. Removable Vacuum Tank 3. Solution tank 9. Switch plate 4. Solution Hose Connector 10. 6” wheels 5. Motor base housing 11.
- Page 4 8070 MYTEE-LITE™ FILL SOLUTION TANK ATTACH HOSE Firmly attach hose and quick disconnect. Make sure quick discon- Remove vacuum tank to fill solution tank (See release latch portion). For best results, fill with warm water (140 o F). nects snap together firmly. Once attached to unit connect Q.D. to upholstery tool.
- Page 5 To drain recovery tank, detach and empty from vacuum inlet. Add a defoamer in the recovery tank to reduce foam, prolonging Detach: Flip-up latch. Attach: Place latch. the life of the Mytee Lite™ vacuum motor . Twist counter clockwise Twist clockwise for release.
- Page 6 If damage is evident, save the shipping carton so that it can we at Mytee Products Inc. strive to keep you on the cutting edge with superior be inspected by the carrier that delivered it. Contact the carrier immediately to file a quality and technology.
- Page 7 4. Filters clogged, remove filters and rinse clean with water. 8. Wait 8–10 minutes for unit to pre-heat. 5. Heater is blocked; flush out with Mytee’s system maintainer. 9. Re-key upholstery tool until hot water begins flowing. 6. If brass check valve is stuck replace valve.
- Page 8 EVENT SHALL MYTEE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, PROPERTY DAMAGES, OR PERSONAL INJURIES. All limited warranties are void for, and Mytee does not warrant in any way, any prod- uct that evidences misapplication, improper installation, abuse, lack of maintenance,...
- Page 9 8070 MYTEE-LITE™ PARTS & PRICING Part prices are subject to change. Order parts at: http://www.mytee.com/products/8070-mytee-lite-ii-automotive-detail-extractor...
- Page 10 8070 MYTEE-LITE™ PARTS & PRICING...
- Page 11 8070 MYTEE-LITE™ WIRING DIAGRAM...
- Page 12 NOTES Mytee Products Inc. 13655 Stowe Dr. Poway, Ca. 92064 www.mytee.com © 2013 Mytee Products Inc. Printed in the U.S.A.