Introduction - Danfoss VLT HVAC Drive FC 102 Programming Manual

Introduction

1 1
1 Introduction
This guide can be used with all
®
VLT
converters with software version
The actual software version
number can be read from
parameter 15-43 Software Version.
Table 1.1 Software Version
This publication contains information proprietary to
Danfoss. By accepting and using this manual, the user
agrees that the information contained herein is used solely
for operating equipment from Danfoss, or equipment from
other vendors if such equipment is intended for communi-
cation with Danfoss equipment over a serial
communication link. This publication is protected under
the Copyright laws of Denmark and most other countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual functions properly in every physical, hardware, or
software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance,
or fitness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost profits or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
4
VLT
®
VLT HVAC Drive
FC 102 Series
HVAC Drive frequency
4.x.
Danfoss A/S © 03/2015 All rights reserved.
®
HVAC Drive FC 102
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users
of such revisions or changes.
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations that
may result in damage to equipment or property.
60° AVM
A
AC
AD
AEO
AI
AMA
AWG
°C
CD
CDM
CM
CT
DC
DI
DM
D-TYPE
EMC
EMF
ETR
60° asynchronous vector modulation
Ampere/AMP
Alternating current
Air discharge
Automatic energy optimisation
Analog input
Automatic motor adaptation
American wire gauge
Degrees celsius
Constant discharge
Complete drive module: the frequency
converter, its feeding section and its auxiliaries
Common mode
Constant torque
Direct current
Digital input
Differential mode
Drive dependent
Electromagnetic compatibility
Electromotive force
Electronic thermal relay
MG11CE02