Danfoss VLT HVAC Drive FC 102 Programming Manual page 38

Parameter Descriptions
0-74 DST/Summertime
Option:
3 3
[0] Off
*
[2] Manual
0-76 DST/Summertime Start
Range:
Size
related
*
0-77 DST/Summertime End
Range:
Size
related
*
0-79 Clock Fault
Option:
[0] Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below the parameter
number in the display. Press [OK] and step between elements
▲
with [ ] and [
Option: Function:
Set for each weekday if it is a working day or a non-
working day. First element of the array is Monday. The
working days are used for timed actions.
[0] No
[1] Yes
0-82 Additional Working Days
Array with 5 elements [0] - [4] displayed below the parameter
number in the display. Press [OK] and step between elements
▲
with [ ] and [
Range:
Size related
*
36
Function:
Select how daylight saving time/summertime
should be handled. For manual setting of DST/
summertime, enter the start date and end date in
parameter 0-76 DST/Summertime Start and
parameter 0-77 DST/Summertime End.
Function:
[ 0 - 0 ] Sets the date and time when DST/
summertime starts. The date is
programmed in the format selected in
parameter 0-71 Date Format.
Function:
[ 0 - 0 ] Sets the date and time when DST/
summertime ends. The date is
programmed in the format selected in
parameter 0-71 Date Format.
Function:
Enables or disables the clock warning when the
clock has not been set, or has been reset due to a
power-down and no back-up is installed. If MCB
109 is installed, [1] Enabled is default.
▼
].
▼
].
Function:
[ 0 - 0 ] Defines dates for additional working days
that would normally be non-working
days according to parameter 0-81 Working
Days.
Danfoss A/S © 03/2015 All rights reserved.
®
VLT HVAC Drive FC 102
0-83 Additional Non-Working Days
Array with 15 elements [0] - [14] displayed below the parameter
number in the display. Press [OK] and step between elements
▲
with [
Range:
Size related
0-89 Date and Time Readout
Range:
0 [0 - 25 ] Displays the current date and time. The date and
*
▼
] and [ ].
Function:
[ 0 - 0 ] Defines dates for additional working days
*
that would normally be non-working
days according to parameter 0-81 Working
Days.
Function:
time is updated continuously.
The clock does not begin counting until a setting
different from default has been made in
parameter 0-70 Date and Time.
MG11CE02