Swivel Adjustment; Adjusting The Vesa Mount - StarTech.com ARMDUOSS User Manual

Swivel Adjustment

The Monitors can be adjusted on a 360-degree swivel.
•
Place both of your hands on either side of the Monitor and apply light pressure
either left or right. The Monitor will swivel 360 degrees.

Adjusting the VESA Mount

If the Monitors are not staying in place, the Hex Screw on the back of the VESA
Monitor Mount will need to be tightened. This Hex Screw may also need to be
loosened in order to readjust the position of the Monitors.
1. Remove the VESA Monitor Mount from the Plate by turning the Screw on the
side of each of the VESA Monitor Mounts counterclockwise to loosen the VESA
Monitor Mounts.
2.
Lift the Monitors straight up and out of the Plates.
3.
Place the Monitors screen side down on a scratch-free surface.
4.
Remove the Monitors from the VESA Monitor Mounts by loosening all
four Screws on each of the VESA Monitor Mounts, using a Phillips Head
Screwdriver. Remove the Screws, the VESA Monitor Mounts, the Washers and
any Spacers that may have been used for the installation.
5.
Hold the Plastic Disc (located on the front of the VESA Monitor Mount) in
place using Needle-nose Pliers. While holding the Plastic Disc, tighten the Hex
Screw, located on the back of the VESA Monitor Mount, using the M5 Hex Key.
(Figure 10)
Note: These Hex Screws can be loosened in order to adjust the position of the
Monitors. Always tighten these Hex Screws immediately after adjusting the
position of the Monitors. A second person may be required to hold the Monitor
after adjusting its position.
6.
Once the Hex Screw is tightened, re-attach the VESA Monitor Mount.
11