Receiver's Antenna Installation - FUTABA T10J Manual

RECEIVER's ANTENNA INSTALLATION

The R3008SB has two antennas. In order to maximize signal reception and promote safe
modeling Futaba has adopted a diversity antenna system. This allows the receiver to obtain RF
signals on both antennas and fly problem-free.
To obtain the best results of the diversity
f u n c t i o n , p l e a s e r e f e r t o t h e f o l l o w i n g
instructions:
1. The two antennas must be kept as straight
as possible. Otherwise it will reduce the
effective range.
2. The two antennas should be placed at 90
degrees to each other.
Antenna
*The two antennas should be placed at 90 degrees to each other.
*The Illustration demonstrates how the antenna should be placed.
*Receiver Vibration and Waterproofing: The receiver contains precision electronic parts. Be sure to avoid vibration,
shock, and temperature extremes. For protection, wrap the receiver in foam rubber or other vibration-absorbing
materials. It is also a good idea to waterproof the receiver by placing it in a plastic bag and securing the open end of the
bag with a rubber band before wrapping it with foam rubber. If you accidentally get moisture or fuel inside the receiver,
you may experience intermittent operation or a crash. If in doubt, return the receiver to our service center for service.
30
*Must be kept as straight as possible.
Antenna
Coaxial cable
R3008SB Receiver
This is not a critical figure, but the most
important thing is to keep the antennas
away from each other as much as possible.
Larger models can have large metal
objects that can attenuate the RF signal. In
this case the antennas should be placed
at both sides of the model. Then the best
RF signal condition is obtained at any flying
attitude.
3. The antennas must be kept away from
conductive materials, such as metal,
carbon and fuel tank by at least a half
inch. The coaxial part of the antennas does
not need to follow these guidelines, but do
not bend it in a tight radius.
4. Keep the antennas away from the motor,
ESC, and other noise sources as much as
possible.
Antenna