Fail Safe - FUTABA T10J Manual

Fail safe

FAIL SAFE
Function
When normal radiowaves cannot be received due
to noise and interference, the NOR mode, which
holds the servo of each channel in its position
immediately before reception was lost, or F/S (Fail
Safe) mode, which moves the servo of each channel
to a preset position, can be selected. When T-FHSS
Air is selected, the battery fail safe voltage can be
set.
●When the throttle channel was reversed by servo
reverse function, the F/S data is also reversed.
(Throttle channel only) If the receiver battery
voltage drops below the set value when the fail
safe mode was selected, the battery fail safe
function moves the servo to a preset position.
●The S-FHSS fail safe voltage is 3.8V.
●Only the throttle channel battery fail safe function
can be turned on and off.
Method
Calling the setting screen
① Call the menu screen from the
home screen by pressing the + key
for 1 second.
＋
（1 second）
F/S Position
Mode select
● Select the setting item
with the Jog key.
Fail safe
■ Mode selection
① Select the mode by
pressing the + key or
– key at the MODE
item of each channel.
＋ －
or
（Range）
NOR, F/S
"Fail safe"
② Select
from the menu with the Jog
key.
FAIL SAFE
MODE. POSI
1: AIL ▶NOR
2: ELE ▶NOR
3: THR ▶F/S
4: RUD ▶NOR
5: GER ▶NOR
（When F/S mode was selected）
■ F/S position
② In the mode selected state, set the F/
S position by holding the stick of that
channel in the position you want to set
and press the Jog key for 1 second.
● A confirmation beeping sounds to
show that the servo position was
set.
●When this function was performed reset the battery
fail safe function by the following method and
immediately land.
Reset method：
T he battery fa il saf e fu n ction can be
temporarily disabled by moving the throttle stick to the slowest
side. However, after 30 seconds the battery fail safe function will
return to the battery fail safe state.
WARNING
For safety, always set the fail safe functions.
●Remember to set the throttle channel fail safe function so that
the servo moves to the maximum slow side for airplanes and
to the slow side from the hovering position for helicopters.
Crashing of the model at full high when normal radio waves
cannot be received due to interference, etc., is very dangerous.
●If the battery fail safe is reset by the throttle stick, it may
be mistaken for an engine malfunction and will be reset at
throttle slow and the model will continue to fly. If you have
any doubts, immediately land.
③ Open the setting screen by
pressing the Jog key.
1 2 3 TFHSS
B-F/S : ON/OFF
B-F/S
20% ACT
■ When using the B-F/S mode
① Select ACT by pressing the + key or
– key at the B-F/S item.
＋
（Range ／ Default）
INH, ACT ／ INH
(Common)
－
or
45