Table of Contents
Advertisement
WARNING & ERROR DISPLAYS
An alarm or error indication may appear on the display of your transmitter for a number of
reasons, including when the transmitter power switch is turned on, when the battery voltage is
low, and several others. Each display has a unique sound associated with it, as described below.
LOW BATTERY ERROR: Warning sound: Continuous beep until transmitter is powered off.
The LOW BATTERY warning is displayed when the transmitter battery voltage drops below 4.1V.
MIXING ALERT WARNING: Warning sound: Several beeps repeated until problem resolved or
overridden.
issued at power-up are listed below. Throttle cut, idle-down, snap roll, airbrake, throttle-stick
and condition. If turning a switch OFF does not stop the mixing warning: The functions
described previously probably use the same switch and the OFF direction setting is reversed.
In short, one of the mixings described above is not in the OFF state. In this case, reset the
warning display by pressing both ＋ / － KEY at the same time. Next, change one of the
switch settings of the duplicated mixings.
*If "ESC mode" is chosen by "THR.CUT", a THR CUT will not start warning.
BACKUP ERROR: Warning sound: Several beeps (repeated continuously)
The BACKUP ERROR warning occurs when the transmitter memory is lost for any reason. If this
occurs, all of the data will be reset when the power is turned on again.
A setup of warning of each sensor can be performed in TELEMETRY .
26
Land your model as soon as possible before loss of control
due to a dead battery.
The MIXING ALERT warning is displayed to alert you whenever
you turn on the transmitter with any of the mixing switches
active. This warning will disappear when the offending switch
or control is deactivated. Switches for which warnings will be
Do not fly when this message is displayed: all programming
has been erased and is not available. Return your transmitter to
Futaba for service.
TM
"TM" mark is shown about warning of TELEMETRY.
Advertisement
Table of Contents
