R3008Sb Ch Mode - FUTABA T10J Manual

Extra Voltage Connector
Use this connector when using a voltage
telemetry device to send the battery voltage (DC0
~ 70V) from the receiver to the transmitter.
You will need to purchase the optional External
Voltage input cable (CA-RVIN-700) FUTM5551.
You can then make a cable with an extra
connector to the External voltage connector.
Danger
Don't touch wiring.
* There is a danger of receiving an electric shock.
Don't short-circuit the battery terminals.
* A short circuit across the battery terminals may cause
abnormal heating, fire and burns.
Please double check your polarity ( ＋ and
－ ) when hooking up your connectors.
* If ＋ and － of wiring are mistaken, it will damage,
ignite and explode.
Don't connect to Extra Voltage before
turning on a receiver power supply.

R3008SB CH MODE

The R3008SB receiver is a very versatile
unit. It has 8 PWM outputs, S.BUS and S.BUS2
outputs. Additionally the PWM outputs can be
changed from channels 1-8 to channels 9-10. If
you only desire to use it as an 7 channel receiver
(without S.BUS), it can be used without any
setting changes.
Output
connector
1
2
3
4
5
6
7/B
8/SB
Red LED blink
How to change the R3008SB Channel mode
The R3008SB is capable of changing its channel
allocations as described in the table below.
1. Turn on the receiver. (At this moment, the
2. Press and hold the Mode Switch more than
3. Release the button when the LED blinks
4. The receiver is now in the "Operation
5. By pressing the Mode Switch, the operation
6. The operation mode will be set by pressing
7. Release the button when the LED blinks
8. After confirming the operation CH mode
R3008SB CH Mode table
Channel
Mode Ａ Mode B
1 ～ 8CH 1 ～ 7CH
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 S.BUS
1 time 2 time
Default CH mode
transmitter should be off.) Then, LED blinks
RED in about 3 seconds. Next, wait until it
becomes solid RED.
5 seconds.
RED and GREEN simultaneously.
CH Set" mode. At this moment, the LED
indicates current set status through flashing
a pattern that corresponds to the CH
mode.
*Cannot exit this CH setting mode before the operation
mode is fixed.
*See the below table that shows correspondence between
"CH mode" and way of flashing LED.
*Default CH mode is "Mode B".
CH is switched sequentially as "Mode C"
"Mode D" "Mode A"....
the Mode Switch more than 2 seconds at
the desired CH mode.
RED and GREEN simultaneously. Then, the
operation CH is fixed.
is changed, turn off and back on the
receiver power.
*The "Operation CH Set" mode cannot be changed during
the receiver communicates to the transmitter.
Mode C Mode D
9 ～ 10CH 9 ～ 10CH
9 9
10 10
－ －
－ －
－ －
－ －
－ －
－ S.BUS
3 time 4 time
29