IBM 9348 Service Information page 93

CAUTION:
When the unit is extended, its
weight can turn over a rack that is
not steady. Before you pull the
unit out of the rack, ensure that a
rack stabilizer is attached to the
bottom front of the rack.
Do not pull out more than one unit
at a time. The rack can turn over
if you pull out more than one unit
at a time.
Pull the release lever located
under the front panel as shown.
Then pull the tape unit out of the
rack until the slide locking tabs
lock.
Remove the two TORX (T25)
screws holding the top of the front
panel to the frame.
Chapter
3.
Service Procedures
3-31