Table of Contents
Advertisement
Warning: Use antistatic mats and
either wrist or heel straps to
prevent static damage during
repair.
Remove the card enclosure cover
on the right side of the tape unit.
Note: Each end of the cover is
held by a spring-loaded screw.
Use a flat-blade screwdriver to
loosen the screws, if necessary.
6
Remove the cards as needed.
Disconnect the read and write
cables from the readlwrite card
before removing the card. The
cards can only be installed in their
own slots because the sockets on
the cards are offset.
The location of the cards, from the
center of the tape unit to the outer
edge of the tape unit are:
Readwrite card
Controller card
RH36103-0
Chapter 3. Service Procedures
3-1 7
Advertisement
Table of Contents
