Table of Contents
Advertisement
Pivot Locking Screws
CAUTION:
When the unit is extended, its
weight can turn over a rack that is
not steady. Before you pull the
unit out of the rack, ensure that a
rack stabilizer is attached to the
bottom front of the rack.
Do not pull out more than one unit
at a time. The rack can turn over
if you pull out more than one unit
at a time.
Press the release lever located
under the front panel as shown.
Then pull the tape unit out of the
rack until the slide locking tabs
lock.
Press the locking tabs at the rear
hole on the slides.
Pull the tape unit forward until the
locking tabs lock in the front hole.
Chapter 5. Safety Inspection Guide
5-5
Advertisement
Table of Contents
