Motors And Hubs Removal - IBM 9348 Service Information

Motors and Hubs Removal
The same procedure is used to
remove either the supply motor, or
the take-up motor, and their hubs.
If only a hub is being removed,
only do steps 3 and 4.
Place the tape unit in the service
position; see "Placing the 9348 in
the Service Position" on page 3-1.
Disconnect the motor power cable
from the MotorIPower card.
The supply motor connector is
J1
The take-up motor connector is
J 3
3-78
9348 Service Information